Technical data

Insert the splash guard into the top hole of the gravity

feed tube

Lightly lubricate both orings on each tube with the

sanitary lubricant. When finished, place a feed tube

uninstalled at the bottom of each mix tank

Lubricate

The machine is now completely assembled and ready

to be sanitized

Assembling the Mix Injection

Pump

Before assembling the mix injection pump, locate all of

the parts that will be required. (See Below)

First install the small or ing

(#3

1) onto the pressure

relief plunger (#105) and lightly lubricate the oring.

NOTE: Oring

#I126

is slightly smaller than the

other orings used on this assembly. Locate these

orings, first and install.

Assemble the connecting tube (#207) with the check

valve

(#3

1) and orings (#1126) and (#1117) Lightly

lubricate the check valve before installing into the

connecting tube. Lightly lubricate both orings

Install the two orings

(#1126) into the bottom grooves

of'the feeding elbows (#32) then lightly lubricate

Install the assembled pressure relief plunger into the

feed elbows, small end first Next install the assembled

connecting tube into the mix feed elbow, check valve

first The feeding elbows are now completely

assembled and can be placed into the bottom of the mix

storage tanks.