Technical data

Insert the beater assembly into the freezing cylinder.

Holding the beater horizontal, gently slide it straight

into the cylinder until it can go no farther

Once installed, rotate the beater assembly to engage the

beater frame into the drive coupling in the

transmission This engagement will allow the beater

frame to go another

into the cylinder Push the

beater frame until it can go no further

After installing and engaging the beater assembly,

rotate the center idlers to a vertical position. This will

ensure that they will correctly engage the pins on the

rear of the dispensing head

Assembling the Dispensing Head

Locate the parts that will be needed to assemble the

dispensing head These parts include: A) Dispensing head

oring,

Dispensing head,

Piston orings

(2),

D) Piston,

Handle retaining rod,

Dispensing handle,

and I) Retaining rod oring.

After locating all of the required parts, start by assembling

orings onto the piston

Install the center piston oring onto the center piston.