Technical data

D) Disassembling the Beater

Auger

Remove the beater

auger assembly eom the cylinder

by pulling straight out of the machine towards you.

Disassemble the beater

auger by first removing the

rear rubber beater shaft seal.

Finally, remove the beater

auger end pusher by

pulling straight out of the beater

auger frame

Remove the scraper blades fiom the beater /auger fia-

me by gently rotating the blade out of the fiame

support brackets

The machine is now completely disassembled. The

removed parts must now be washed, rinsed, and

sanitized.

E) Cleaning Operation

Wash the removed machine parts in luke warm (80-90

F) water and mild non-foaming detergent Scrub each

of the parts with the cleaning brushes provided in the

machines spare parts kit.

IMPORTANT

NOT

use hot water

any oj the plastic parts as

this may result

damaging these parts

Air

Dry

Next disassemble the center idler fiom the beater

auger frame To remove, pull the idler straight out of

the front of the beater

auger.

Using your three-tank sink, wash rinse, and sanitize all

of the disassembled machine parts. Mix the sanitizing

solution to a

200ppm concentration with warm water.

Allow the parts to soak in the sanitizing solution for

minutes before removing Allow the parts to air-dry

on the clean, sanitized counter at the end of the sink

NOTtowel or sponge dry these parts