Technical data
DO NOTattempt to operate the freezer while low on
mix or your freezer may be damaged.. It is also possible
to activate a beeper to sound when mix is low in the
Automatic and Stand-By modes.. This is done through
the programming mode
B)
Dispensing Handle
-
(Refer to Figure
5)
The dispensing handle control the flow and extraction
rate of finished product
You should
ONLY
dispense product when the machine'
is in the automatic mode
--\
Figure
5
C) Photo Sensor Switch
-(Refer to Figure
6)
In the Automatic mode the Photo Sensor Switch
(Position #152) activate the beater
1
auger motor to
dispense product To activate the photo sensor switch,
simply place your hand with a cone or cup under the
dispensing head, pull the dispensing handle and
dispense product.
NOTE You must activate the photo sensor switch,
starting the beater drive motor pr ior to dzspensing
product
D) Dispensing Head Safety Switch
This machine is equipped with a dispensing head safety
switch With the dispensing head removed, the machine
will not operate and Alarm
9
(AL9) will appear on the
front touch pad monitor Please refer to machine alarms
on page
28
for more details
E)
Electrical Control Panel
-
(Refer to figure
7)
The electrical control panel is located on the top of
the front panel This control panel contains all of the
machines electrical control components
ONLY
a
Coldelite Authorized Technician should access this
control panel
!!
IMPORTANT WARNING
!!
Disconnect the, freezer power supply before
opening the Electrical Control Panel and/or
servicing.
7
4
1
2
Figure
7
The following is an explanation of'some ofthe
components inside the electrical control panel..
1) Beater Motor Contactors
-
Activates the beater
drive motor In the "BEATER" mode, the contactor is
energized by the front switch pad In the "AUTO
mode, the contactor is energized by the photo sensor or
10
minute cycling timer
2)
Compressor Contactor
-
Activates the refrigeration
compressor. When the unit is in the "AUTO mode, the
compressor contactor can be energized by the
electronic HOT setting or the Tev Temperature probe.
In the "Stand-By" mode, the contactor is energized by
the Tev and Tec temperature probes
Figure
6