Installation Guide

Introduction

To ensure a simple and hassle-free installation, read this guide before commencing installation.

Coldbuster does not accept responsibility for any loss or consequential damage suffered because of

installations that in any way contravene the instructions detailed in this guide.

If you require further assistance, please contact Coldbuster.

Installation Dos and Do Nots

Do:

• Ensure all heaters are installed as per these instructions

• Ensure the floor surface is smooth, clean and dry before installing heaters

• Start each heater cold tail on the floor below the thermostat point

• Plan installation layout before starting, especially when more than one heater is being installed

• Protect the heater with cardboard or hardboard if the floor covering installation is delayed

• Test heaters before installing the floor covering (ensure monitor is connected, turned on, and no

siren sounding)

• Ensure adhesives and grouts are suitable for use with floor heating

• Ensure the heater is connected to an RCD (safety switch) protected circuit

• Retain your invoice as proof of purchase for warranty purposes

• Complete the last page of this booklet for future reference

Do Not:

• Cut heating element EVER

• Allow heating elements to touch or cross one another

• Place sharp or heavy objects on uncovered heaters

• Install heaters under any surface not suitable for that particular floor heating

• Install heating in shower recesses without builder’s prior approval

• Commence installing the final floor cover before testing heaters

• Only run the heating after the adhesive & grout has cured for a week