Specifications

COLASIT AG
Plastic construction
CH-3700 Spiez
Phone [phone] Fax [phone]
Edition 2011 / Subject to alteration
Copyright by COLASIT AG Spiez
Page 24
19.2 ATEX-Declaration of Conformity
ATEX-Declaration of Conformity
Equipment, components and protection systems for use for their intended purpose in explosion protected
zones – Directive RL 94/9/EC (ATEX)
Document number : TD-000 744
Product designation: Medium pressure radial fan CMVeco 125-400 ATEX
Hersteller: COLASIT AG
Postfach 85
3700 Spiez
Product description Plastic industrial fan fort he conveyance of chemically
aggressive gases, vapour or correspondingly contaminated air.
The conformity assessment process was conducted in compliance with Directive 94/9/EC (ATEX).
The results are recorded in the confidential Test Report TD-T586-21-3. All related documents are kept at
the centres named below:
QS Zürich AG, named centre CE 1254
Wehntalerstrasse 3
CH-8057 Zürich
COLASIT hereby certifies compliance with the basic health and safety requirements for the design and
manufacture of equipment and protection systems for use for their intended purpose in explosive
atmospheres in compliance with Annex II of the Directive.
The following harmonised standards were applied:
EN 1127-1: Explosive atmospheres – Explosion protection, Part 1, 2008
EN 13463-1: Non-electrical equipment for potentially explosive atmospheres, Part 1, 2009
EN 13463-5: Non-electrical equipment for potentially explosive atmospheres, Part 5, 2005
EN 14986: Design of fans working in potentially explosive atmospheres, 2007
The marking on the appliance must comprise the following information:
II 3/- G c T4 (conveyed medium Zone 2, site of installation no zone)
II 3/3 G c T4 (conveyed medium Zone 2, site of installation no Zone 2)
II 2/3 G c T4 (conveyed medium Zone 1, site of installation no Zone 2)
II 2/2 G c T4 (conveyed medium Zone 1, site of installation no Zone 1)
The associated operating instructions contain important safety instructions and regulations for putting the
named equipment into operation in compliance with Directive 94/9/EC (ATEX).
Changes to the named equipment are prohibited except with the manufacturer's express approval in writing.
If the named equipment is built into a higher level machine, the new risks ensuing from the integration must
be assessed by the manufacturer of the new machine.
Spiez, 21st. September 2009
Der ATEX-Officer On behalf of the executive management