Installation, use and maintenance manual Wood-burning stove model EMILY 48.41.10.021.
1 - GENERAL INFORMATION 1.1 Introduction 1.2 Safety rules 1.3 Technical description 1.3.1 Ash and fire door 1.3.2 Primary air control 1.3.3 Secondary air 1.4 Fuel 1.5 Accessories supplied 1.6 Reference standards 1.7 Dataplate 1.8 Instructions for ordering replacement parts 1.9 Stove decommissioning 2 – TRANSPORT AND INSTALLATION 2.1 Packing, handling, shipment and transport 2.2 Instructions for safe installation 2.3 Connection to the flue 2.4 Room ventilation 2.
1 - GENERAL INFORMATION 1.1 Introduction Dear Customer First of all we wish to thank you for the trust placed in us by purchasing one of our products. Please read and carefully follow the advice given in this installation, use and maintenance manual in order make best use of the product.
1.3 Technical description The wood-burning stove is suitable for natural convection heating of homes and meets the requirements of Standard EN 13240 and Standard EN 12815 Structure steel and cast iron Combustion chamber cast iron Nominal heat output 6.7 kW CO with 13% O2 0.304 % Efficiency 76 % Fume outlet pipe Ø 120 mm Required draught 10-14 Pa Max. flue gas temperature 292.3 ° C Heatable volume 65 - 165 m³ (depending on house insulation) Max. hourly wood consumption 1.
1.3.1 Firebox door (B) and ash opening (D) To open the door pull the handle outwards. A protective glove is supplied for opening the stove fire door (the handle becomes very hot). The ash zone has an adjustable combustion air inlet opening for use during the lighting stage. 1.3.2 Primary air control (A) By means of the revolving air control on the firebox door the primary air can flow into the lower part of the stove through the ash pan and grate.
1.7 Dataplate The dataplate is located on the back of the stove. It contains the following data: - model; - hourly consumption; - serial number; - flue pipe size; - type of fuel; - stove external dimensions; - nominal heat output; - safety distance; - CO content with 13% O2; - weight. - thermal efficiency; 1.8 Instructions for ordering replacement parts For the end-user: Contact the service centre and/or your dealer to request replacement parts.
2.4 Room ventilation The air necessary for combustion, i.e. up to 20 m³ every hour, must be ensured in rooms where stoves with natural flue draught are installed. The air change must occur through several fixed openings to the outside, whose cross section must comply with the current local regulations. Such openings must be protected with grilles and must never be obstructed.
Before connecting stove to an existing chimney, in addition to complying with that described above, make sure there are no openings or cracks where air could enter and cause a temperature decrease affecting the draught. Also make sure there are no hindrances caused by foreign bodies or a build-up of soot.
3.4 Lighting and controlling the fire To light the fire, it is advisable to use kindling and newspaper, or other means available on the market (excluding any solid or liquid flammable and/or explosive substance). The air control on the ash door must be open, and is used for adjusting stove heat output after the lighting stage. 3.5 Normal operation Remove the ash from the grate every time before loading fuel. Put 2-3 logs of wood on the bed of embers for even consumption and good efficiency.
4.3 Cleaning the flue A reduction in heat output is nearly always due to obstruction of the flue. Also, the presence of burnt gases with odours can be a sign of an obstructed flue. The flue of your stove must be cleaned at regular intervals. The amount of soot and the frequency of cleaning will depend largely on the type of fuel and the type of use (low or high heat output).
6– ENCLOSURES 6.1 Warranty certificate For the warranty terms contact the importer or the authorised agent. The product warranty is cancelled in case of any problem, breakage or accident due to non-compliance with the instructions given in this manual. The company reserves the right to make technical or aesthetic modifications to the products at any time without notice. The drawings, measurements, diagrams and any other configurations are given only by way of example.
6.2 "CE" marking information CE MARKING INFORMATION Anselmo Cola 07 EN 13240 : 2001 + A2 : 2004 Apparecchio domestico a combustibile solido Roomheater fired by solid fuels Ref.
