User manual

(1) Lens Mount Allows a C-mount or CS-mount lens to be attached.
(2) Red Image Capture LED Programmable LED. By default, it flashes when the camera
captures an image when a user is connected to the camera.
It also indicates the level of focus when using the focus
utility.
(3) Power Input Power input for the camera.
(4) RJ45 Ethernet Port Accepts an RJ45 Ethernet connector.
(5) DB9 Serial Port Allows users to perform out-of-band camera management.
(6) Screw Terminal Relay I/O Allows users to attach an external device such as an
infrared motion sensor.
(7) Hardware Address Necessary when assigning an IP address to the camera.
(8) Status Lights Status showing Ethernet activity and camera status.
(9) Reset/Camera Focus Button Factory reset button and camera focus button
1.4 Installation Basics
The Cohu 7100 Series camera becomes operational once it is:
1. Connected to an Ethernet network using twisted-pair Ethernet cable
2. Connected to its power supply and plugged into an ordinary electrical outlet
3. Assigned an IP Address
Note: If the camera is installed on a network that uses a DHCP server to assign IP
addresses, the DHCP feature should be enabled in the camera. See RARP/DHCP/BOOTP
in Section 4.2 for more information.
Once an IP address is assigned to the camera, the camera is accessed from a web browser by
typing the IP address into the browser s URL/Location field.
8 of 60