User manual

Once the continuity checker is properly connected, you must configure the camera s relay to open
and close according to the Red Image Capture LED, which enables the Audible Focus Utility.
To configure the camera's relay:
1. Telnet to your camera.
2. Become the privileged user.
3. Issue the TEST IMAGE FOCUS command.
Initiate the camera s focus utility by inserting the end of a bent paper clip into the Focus/Factory
Reset slot on the back of the camera to depress the Focus/Factory Reset button.
Note: Be certain that the camera is not powering up before you press the button. The
camera should be in its normal operating cycle, indicated by the Green Status LED
flashing at two-second intervals, when you depress the Focus/ Factory Reset
button.
Once you initiate the Focus Utility, the continuity checker should begin to beep. While using the
focus utility, if the continuity checker is making a noise, your camera is going out of focus. When
the continuity checker is silent, your camera should be coming into focus.
Note: Be sure not to block the camera s view while using the Focus Utility.
1. Slowly rotate your lens (or focus-ring) as you listen to the continuity checker. The
continuity checker will beep when the lens is going out of focus. As the image comes
into focus, the continuity checker will become silent.
2. Once the continuity checker becomes silent, continue to rotate the lens (or focus-ring)
in the same direction until the continuity checker begins to beep again.
3. Reverse the direction, rotating the lens (or focus-ring) slower than before, until the
continuity checker again turns off then on.
Repeat step 3 above, switching directions and using slower and slower motion, until there is little
movement necessary until the continuity checker makes a noise.
Note: You can verify the focus by looking at an image from your camera.
57 of 60