User manual

The possible results are:

Result Explanation

Success All images transferred properly.

CWD The camera failed to change directories into the one specified in the FTP path setting.

Send

The camera failed to send the file. This error is usually caused by a network error or a

full disk.

MKD

The camera failed to make the directory specified in the FTP path setting. Either

permission was denied, the disk was full, or the path contained invalid characters for

the FTP host.

Memory

The camera is out of memory. Check the memory statistics by issuing a SHOW

SERVER command during a command line connection. Refer to the Reference

Manual for more information about command line connections.

Connect

The camera failed to connect to the FTP server. Check that the name or IP address for

the FTP server is correct. If the name or IP address is correct, use another device to try

to establish a connection with the FTP server.

Name resolution

The camera could not resolve the FTP host name to an IP address. Check nameserver

and domain name settings on the camera. Use another device to try to establish a

connection with the FTP server by the FTP server name

Socket create The camera could not create a network socket.

Open

The camera could not open the local trigger file. Either no image was taken

or the disk is full. Do a DISK LS -L on the /ram disk to see if the trigger file(s) update

when you issue a TEST TRIGGER INPUT command. Refer to the Reference Manual

for more information about command line connections.

Configuration

The FTP settings are not configured properly (i.e. something is not filled in).

None

The camera has not made an FTP attempt yet.

Command

The specified FTP host did not understand one or more of the commands issued by

the camera.

Once you configure the FTP settings, use the Trigger Now link on the Trigger Settings page to

verify that your camera is properly configured. Pressing this link will manually initiate a trigger

event, forcing the camera to initiate an FTP session with the specified remote server. When all

Trigger/FTP settings are correct, the camera will successfully transfer trigger images to a remote

FTP server. You may wish to log into the external FTP server to verify that an image sequence

was placed there, and that the images were placed in the appropriate folder with the appropriate

name.

44 of 60