Specifications

Cohda Wireless|Cohda XBU-V Specification | 25/03/2019 | Commercial in Confidence
Radio 5GHz Antenna Connectors
The internal Ant1 and Ant2 connectors provide connectivity to the two 5GHz band diversity antennas. Each
connector is a 50 Ohm, Edge mount - male/plug, Key Code Z FAKRA (6GHz) connector.
IMPORTANT: Before applying power antennas (or terminators) must be connected to both 5GHz
antenna connectors. Otherwise the internal PAs (Power Amplifiers) might be damaged.
Indicator LEDs
 Refer Section 0 LED Indicators
Internals
The MK5 Carrier Board is a rectangular card with dimensions 85 mm wide by 130 mm long. Figure 3 shows the
physical dimensions, including the mounting hole locations (marked in blue).
Figure 4 presents the connector heights for the highest components on either side of the PCB.