Owner manual

RTELPORT
Function:The VARIABLEETHERNETRTEL PORT command sets the reverse tel-
net port address.
Command Form:VARIABLEETHERNET RTEL PORT X
Parameters:X (default is 9100)
Comments: Changes to this value are not recommended.
Example:
! 0 0 0 0
VARIABLE READ
VARIABLE ETHERNET RTEL PORT 9100
VARIABLE WRITE
VARIABLE ETHERNET RESET
END
TELNET
Function:The VARIABLEETHERNETTELNET command enables or disables
Telnet communications with the printer.
Command Form:VARIABLEETHERNET TELNET status
Parameters:ON / OFF (default is ON)
Example:
! 0 0 0 0
VARIABLE READ
VARIABLE ETHERNET TELNET ON
VARIABLE WRITE
VARIABLE ETHERNET RESET
END
10
Variable Ethernet Commands