User`s guide

TROUBLESHOOTING

41. Cause: If you are using a high speed Barcode Blaster, the printer

may have received one of the following commands or command

parameters:

MULTIPLE

OFFSET

WIDTH

VARIABLE MODE 1 or VARIABLE MODE 2

Nonzero header line X parameter

These will cause the printer to reduce speed while printing.

Cure: Rewrite your label format to avoid these commands.

Cutter-equipped printer does not cut labels.

Cause: VARIABLE AUTOCUT is OFF, and the label formats do not

contain a HALT command.

Cure: Send the printer a VARIABLE AUTOCUT ON command, or

place a HALT command in each label format.

Random dots on label, or printed labels are truncated at the

bottom.

Cause: The label format exceeds printer memory limits.

Cure: Rewrite the format to use less memory.

Printed label is greatly elongated and is "grayed".

Cause: The label format contains more than one PITCH command.

Cure: Remove any extraneous PITCH commands.