User`s guide

ETHETNET PRINTER INFORMATION

ETHERNET” commands will change the settings printed, but the

printer will not use these new settings until it has been power-cycled.

Note: Turn the printer off and back on again to clear Hex Dump mode and

resume normal operation.

Variable Commands

Several VARIABLE commands support configuration of the Ethernet

printer. Most of these commands execute simple on-off functions, and

accept ON or OFF as their associated parameters. Follow these rules

when using the VARIABLE commands:

Do not use these commands in label formats that print labels.

Enter all commands as shown. You may abbreviate VARIABLE as V,

but do not use any other abbreviations.

You must reset the printer for the commands to take effect. The

VARIABLE ETHERNET RESET command allows you to easily reset

the printer from a remote location via the Ethernet bus.