User`s guide

Loading Media: Standard Size Rolls

Note: Before proceeding to step 1 open the printer cover. Then follow steps 2a or 2b

depending on the media type being used.

Note: Prior to loading media, take a moment to review the

media guides. They are spring loaded to provide improved

media control during printing. The right media guide has

a green locking tab, which holds the guides in place. Once

the guide is set to the width of the media, it can be locked

in place and future loading of media is simplified.

Note:

Once the guides are against the sides of the roll, push the roll down in the slot as

shown. This locks the media guide in the proper position.

Inward Wound Media

Outward Wound Media

Note: Follow steps 3a or 3b depending on media type. For step 4, the media must be placed

under the media guide bar, or media wandering can occur. (thermal transfer models only)

Inward Wound Media

Outward Wound Media

7 8

!" For thermal transfer printers continue to the

loading ribbon section of this Start-Up Guide.

!" For all direct thermal printers go to the

Self-Testing section in this Start-Up Guide.