Operation Manual

42
11. Allow a quantity of water equivalent to approx. 2 to 3 cups of espresso to run through the
machine.
12. Move the START/STOP switch to the "STOP" position.
13. Move the VORHEIZEN AN/AUS (PREHEAT ON/OFF) switch to the "AUS" (OFF) posi-
tion.
14. Empty the espresso pot and then place it back under the espresso discharge opening.
15. Allow the water/descaling agent mixture to take effect for approx. 15 minutes.
16. Repeat steps 9 to 15 approx. 2 to 3 times.
17. The last time you do this, you should let the device run until the water/descaling agent
mixture has been used up.
18. Move the START/STOP switch to the "STOP" position.
19. Move the VORHEIZEN AN/AUS (PREHEAT ON/OFF) switch to the "AUS" (OFF) posi-
tion.
20. Empty the espresso pot and then place it back under the discharge opening.
21. Then ll the water reservoir with clear tap water.
22. Move the VORHEIZEN AN/AUS (PREHEAT ON/OFF) switch to the "AN" (ON) posi-
tion. The rst control lamp on the left will light up as soon as you have switched on the
preheating function.
23. Move the START/STOP switch to the "START" position as soon as the second control
lamp from the left lights up. Water will ow through the espresso discharge opening.
24. Allow one full reservoir of water to run through the espresso machine in order to ush
the lines.
25. Interrupt the ushing by moving the START/STOP switch to the "STOP" position in
order to empty the espresso pot in between times.
26. Move the START/STOP switch to the "START" position to continue the ushing proc-
ess.
27. Move the START/STOP switch to the "STOP" position as soon as the water reservoir is
empty.
28. Move the VORHEIZEN AN/AUS (PREHEAT ON/OFF) switch to the "AUS" (OFF) posi-
tion to switch off the device.
Descaling the Coffee Machine
Use a standard commercial descaling agent to descale the device. Follow the specications
provided by the manufacturer of the descaling agent for details on the mixing ratio.
1. Mix the descaling agent in accordance with the specication on the packaging.
2. Pour the water/descaling agent mixture into the water reservoir.
3. Place the lter insert into the device. The lter insert must be inserted in such a way that
the discharge opening of the lter insert lies in the recess which is provided for it in the
lter compartment.
4. Insert the permanent lter (without any coffee powder).
5. Place the coffee pot on the hotplate beneath the discharge opening.
01327_DE-GB-FR-NL_V1.indb 42 30.09.11 10:58