Instruction manual

English
24
8.6 Connecting DR1 and DR1 Plus
All features are available in the menu can also be activated by DR1 (code CO9707) and DR1 Plus (cod.CO9709). DR1 and DR1
Plus is a tool designed for technicians who can operate the apparatus at the same time the programmer of the show, without
having to physically intervene on headlamps, but controlling functions remotely.
For example, DR1 and DR1 Plus eliminates the need to change a DMX address on the unit, (thus avoiding the technical climbing
on the structure) and can read hours of lamp life and other functions normally accessible from the display. DR1 and DR1 Plus also
allows updating the firmware of the projectors.
To enable a projector to work with DR1 or DR1 Plus, you must set each unit of the line with its own, unique identity number (ID).
WARNING !
- If you set as identification number "0 ", Reflection LEDko will not be recognized by DR1 and DR1 Plus
- Never assign the same ID to two or more units of a same DMX line. This causes the failure of the system. (DR1 and DR1
Plus will display an error message).
For more information see the manual for DR1 or DR1 Plus.
8.6.1 Saving and loading colors banks by using DR1 Plus
DR1Plus allows to store as files, custom color banks on your PC and recall them when required.
To save a custom color bank ( or the default one): click with the right button of the mouse the instance of the unit in the left column,
choose in the pop-up menu: SEND COMMAND/NEW SERIES/GEL COLOR/SAVE; then it will be asked to choose a destination of
the file and after that a warning message to confirm.
To load a bank, click with the right button of the mouse the instance of the unit in the left column, choose in the pop-up menu:
SEND COMMAND/NEW SERIES/GEL COLOR/LOAD; then it will be asked to choose the file to load and after that a warning
message to confirm.
8.7 Electronic alignment of the leds.
The display panel of
Reflection LEDko
allows the electronic alignment of the leds, this procedure is performed by Coemar at the
time of testing, this procedure may be useful for special effects or in case of replacement of internal components (PCBs, leds, etc.
...). Altering the settings made by Coemar may radically alter the functioning of the projector’s functions.
Carefully read the following prior to attempting any changes.
WARNING !
This chapter should be considered for the exclusive use of technicians and qualified personnel.