Instruction manual

English
19
8.3 Main function menu (FUNC)
The projector gives the opportunity to change and customize some functional settings.
FUNC
DIMM.
Dimmer mode: it can simulate dimmer effect with Tungsten or Xenon
lamp.
TUNG
XENO
ID
It allows to set the ID number of the unit by + and – keys; “enter” key to confirm.
Da 1 a n°
COLR
TEST
DISP
It allows to turn 180° the reading of the display. HOLD
locks the keys. Press any key for 5” to unlock.
RVRS
HOLD
AA/VV
ON/OFF
8 CH
DMX
It allows to select the functioning mote at 8 DMX channels without
shade or the extended functioning at 12 channels with selection and
mixing of the shades. The 4 channel features allows to let the
projector to work only with RGB+W channels without dimmer.
4 CH
1 CH It allows to use only the color chosen by dmx and the dimmer.
12 CH
See following sections for details.
8.3.1 FullSpectrum
8.3.2 VariWhite
8.3.3 White 3200K
S.COL
The equipment keeps activated only primary colors RGB/CMY and allows to
make and store custom colors to send to banks of channels 9-10-11
SURE
FullSpectrum Only
D.MAX
RESE
DFSE
Disables the adjusting of the leds setting them at maximum output.
It permits the reset of the unit. Keeping pressed ENTER and MENU at the
turning on of the unit It allows to access ALIG features.
It restores all the settings at default value excepting of led settings and hour
meter.
ON
OFF
enter
SURE
LED
AUTO allows to turn off the display after 6 seconds
AUTO
ON
FRE
It allows to set the flickering frequency from 1000 to 5000 Hz besides
the default value. (NOTE: DMX signals goes ahead this setting)
From 1000 to 5000