Specifications

Strobes Control
Manual Fixtures
When the Fixture LED is lit, press the Fixtures 1-16 button to select what you want
to control manually. The LED above the Fixture number will blink briefly if the
patched fixture is active for manual control, and the message of channel effects
patched for the fixture will appear in the LCD Screen located on the top right.
Move the Faders1-6 to manual control the effects displayed in the Screen.
Meanwhile the joystick can be used to control the two X(Pan) or Y(Tilt) movements
if the Pan or Tile is active(indicated by the lit LEDs).Press the "ok" button to scroll
to the next page if there is more than one page. The fader 1-6 buttons can be
used to call the tabulating values if you've set up the tabulations during the setup
of menu 1.1.9 Control Type.
In addition to 48 shows, this console also allows you to control the fixtures
manually whenever the Fixture LED is lit. Up to 16 patched fixtures are readily
on call, giving you a great flexibility to get to desired effects whether the fixtures
are being used by the shows or not.
This console exclusively allocates 8 DMX channels for the control of the strobes.
There are 20 built-in programs you can select for the chase of up to 4 strobe lights.
The Menu button can be used to access the Program, Speed or Dimmer menu.
Press the Menu button until the message " Pr" appears in the Segment Display.
Use the UP/DOWN buttons to select programs 1-19 or autocycling-program.
The Full On button is used to bring the overall output to full intensity. This function is
enabled when the Full On button is pressed down, and disabled when set free.
Press the Stand By button to activate Stand By mode. Press again to deactivate
this function.
The Full on function takes priority of Stand by if both are active.
Press the Menu button until the message " SP" appears in the Segment Display.
Use the UP/DOWN buttons to select the speed within 1-99 for the current program.
A value of 01 will give you the slowest speed and 99 will give the fastest speed.
Press the Menu button until the message " di" appears in the Segment Display.
Use the UP/DOWN buttons to select the intensity within 1-99 for the program.
A value 01 gives the lowest output and 99 gives full intensity.
0 120 0 0 0 255
COLOR GOBOS G.ROT PRISM SHUTT DIMMR
0
999
42
43
If the fixture is being used by a show, the rest channels not having handled by the
manual control will still be subject to the show. If you want to call off the manual
control over the fixture to restore the manually-affected channels, you can press
either of the Setup and Record button.
Group of fixtures is useful if there are several similar fixtures, which you want to
control at a time, in the patch. Press and hold down the Fixture button, the
message of 6 group code will appear in the Screen. Press the Faders 1-6 button
below the group code display to select a group, the LED will be lit to indicate the
group code. Press the Fixtures 1-16 button to select the fixtures, their LEDs will
blink simultaneously. If the fixtures use the same channel effects, these effect
string will appear in the Screen indicating this group has been established
successfully. If the fixtures' effects are different, a message "different fixture: no
effect control" will appear in the Screen.
Once you've created the groups of fixtures, you can call the group by pressing
the Faders 1-6 button while holding down the Fixture button.