Specifications

ManualsBrandsCoemar ManualsHome building and DecorCF 1200 Hard Edge

Record

This console allows you to record up to 48 shows, chases and scenes. This Section

details the procedures of recording the scene, chase and show. To access the Record

mode, just press the Record button causing its LED to blink briefly, a new window will

appear. To exit the Record mode, press the Record button causing its LED to go out,

or press "esc" until the Record LED goes out.

Press the Show button to access the edit menu, its LED will be lit, and a new

window will appear, indicating you to select the show you wish to edit.

Move the Fader 4 or press UP/DOWN button until the message [ACTIVE EFFECTS]

appears in the Screen. Press "ok" to access this setting menu. This menu allows you

to determine which fixture(s) is which channel(effect) is active

and which one is not.

used by the show,

1. Record Shows

Select what you want to record

esc

Select page and show number

esc

Select the show number using Flash 1-12 together with the Flash page button,

a new window will appear.

SHOW

esc

edit

01 [ -- ]

STEPS

Move the Fader 2 or press Up/Down button to select the number of the step within

1-48. Press ok ("edit") button to access setting menu. This menu has three(3)

options, namely Active Effects, Edit Steps and Step's Time. The following paragraphs

will detail these options respectively.

esc

[ ]ACTIVE EFFECTS

EDIT MENU

1.1 Active Effects

esc

[ ]ACTIVE EFFECTS

EDIT MENU

You will have to select fixture(s) first if no fixture has been selected for the show.

Press the Fixture 1-16 to select the fixture, the LED above the fixture number will

blink briefly and the fixture's effects will appear in the Screen.

Select active fixtures/effects

SELECT FIXTURE

You may select several fixtures at a time, however, only the latest one, whose LED

blinks, is active for the show. Meanwhile, a group of several fixtures can be active

for the show. Several fixtures with the same effects can make up a group. Press

and hold down the Fixture button, and in the meantime p

by The group number is indicated by the lit LED

above the button, and the LEDs of the fixtures in the group will blink simultaneously.

Please take note of selecting the similar fixtures for one group, or a prompt message

will appear indicating you to have a try again.

ress the Fixture 1-16 to

select several similar fixtures to make a group following selecting the group number

pressing the Fader 1-6 button.

Press the Record button to cause its LED to blink briefly, a new window will appear,

telling you to select the show, chase or scene you wish to record.

Select active fixtures/effects

Different fixture: no effect controls

The fixture's effects will appear in the Screen once the fixture is selected. You can

press the Fader 1-6 directly below the effects in the Screen or Pan/Tilt button to

enable or disable these effects. The LEDs corresponding to these effects are lit

when these effects are enabled, whereas the LEDs are off when these effects are

disabled.

Press "ok" to continue your setting if there is more than one page of effects.

When you have finished these settings, please press "ok" or "esc" to return to

the earlier menu.

Select what you want to record

esc