Specifications

1.1.7 Reset/ Lamp Values
Select feature to configure for
esc
ok
FIXTURE NAME - [ ]RESET/ LAMP VALUES
RESET LAMP
[ 12 ]
esc
ok
--
OFF
--
ON
--
OFF
0
ON
255
Setup MenuSetup Menu
14
15
When the LCD Screen shows the message "Create New Fixture", press "ok", then
move the Fader 5 or press UP/DOWN buttons until [ RESET/ LAMP VALUES]
appears in the Screen.
Press "ok", a warning message will appear in the Screen telling you that Reset
or Lamp channel should not be identical to that of Pan, Tilt or Dimmer. Press "ok"
again, a new window will appear requesting you to assign the Reset, Lamp and
their on/off values. This function allows you to carry out Remote Reset and Remote
Lamp on/off if your fixture supports.
ove faders 1-6 to set up Reset and Lamp as well as their on/off
values. Also you can press Forward or Backward to activate an item, then use
Up/Down button to select the settings.
Caution! Please take note you must correctly set up Reset and Lamp functions,
otherwise you will not create a new fixture.
Respectively m
Had you finished your settings, press "ok" to confirm it and return to the earlier menu.
If you want to give up, just press "esc" to return to the earlier menu.
successfully
INTERNAL LIBRARY CONFIGURATION
Select ITEM
[ ]CREATE NEW FIXTURE
Select feature to configure for
esc
ok
FIXTURE NAME - [ ]RESET/ LAMP VALUES
1.1.8 Dip-Switch Configuration
Select feature to configure for
esc
ok
FIXTURE NAME - [ ]DIP-SWITCH CONFIG.
When the LCD Screen shows the message "Create New Fixture", press "ok", then
move the Fader 5 or press UP/DOWN buttons until [ DIP-SWITCH CONFIG.]
appears in the Screen.
Press "ok", a new window will appear indicating you to make a configuration of
dip-switch if necessary. This function allows you to select the Dip-switch and
addressing system that your fixtures use. If your fixtures have new addressing
ove fader 2 to
select the number of switches within 5-10, move fader 5 to select the addressing
system between "0" and "1" - the first denotes a pure binary system, whereas the
second refers to a system that will automatically add a 1 to the address.
setup instead of Dip-switch setup, you can ignore this setup. M
Had you finished your settings, press "ok" to confirm it and return to the earlier menu.
If you want to give up, just press "esc" to return to the earlier menu.
ENTER THE DIP-SWITCH CONFIGURATION
esc
ok
n.dip = [ 10 ] 1st channel = 1 =
INTERNAL LIBRARY CONFIGURATION
Select ITEM
[ ]CREATE NEW FIXTURE
Select feature to configure for
esc
ok
FIXTURE NAME - [ ]DIP-SWITCH CONFIG.