Specifications

Setup MenuSetup Menu
10
11
Once you've completed the effects label of the 1st page, press "ok" to go on with the
2nd page. Repeat the procedures stated in the above paragraph.
Had you finished all effects label, please press "esc" to return to the earlier menu.
The storage is automatic.
1.1.3 Internal Patch
P1
COLOR GOBOS G. ROT PRISM SHUTT DIMMR
[ -- ] -- -- -- -- --
When the LCD Screen shows the message "Create New Fixture", press "ok", then
move the Fader 5 or press UP/DOWN buttons until [ INTERNAL PATCH] appears
in the Screen.
Press "ok", a warning message will appear in the Screen telling you not to
reuse a channel for two or more effects. Press "ok" again, the effect strings
previously created in menu 1.1.2 LCD Effect Label will reappear.
This function allows you to give an assignment of fixture channels according to
fixture profile. Move the r faders 1-6 to select appropriate channel number
for the function effects in the Screen directly above these faders 1-6. Also you can
press Forward or Backward to pass from effect to effect, then use Up/Down button
to select the desired channel number for the underlined effect.
Press "ok" to go on with channel assignment if there is more than one page.
Had you finished all channels assignment, press "esc" to return to the earlier
menu. The storage is automatic.
espective
Select feature to configure for
esc
ok
FIXTURE NAME - [ ]INTERNAL PATCH
INTERN AL LIBRAR Y CONFI GURATION
Sel ec t ITEM
[ ]CREA TE NEW FI XTURE
P2
FOCUS SPEC
[ -- ] -- -- -- -- --
----- ----- ----- -----
1.1.4 Pan/ Tilt Patch
When the LCD Screen shows the message "Create New Fixture", press "ok", then
move the Fader 5 or press UP/DOWN buttons until [ PAN/TILTL PATCH] appears
in the Screen.
Press "ok", a warning message will appear in the Screen telling you that every
Pan and Tilt channel should be solely reserved. Press "ok" again, a new window
will appear requesting you to assign the Pan(X) or Tilt(Y) movement of the fixture.
Move the respective faders 1-4 to select proper channel numbers for Pan coarse,
Pan fine, Tilt coarse and Tile fine movement of the fixture. Also you can press
Forward or Backward to activate an item, then use Up/Down button to select the
channel number for the item.
Had you finished all channels assignment, press"ok" or "esc" to return to the
earlier menu. The storage is automatic.
Caution! Please take note you must assign the Pan or Tilt movement of the fixture
correctly, otherwise you will not create a new fixture.
Most fixtures allow both 8- and 16-bit control, some only 8-bit. In 16-bit mode, the
Pan movement requires two channels, namely high(H) and low(L) position, so does
the Tilt movement. In 8-bit mode, just one channel is used for Pan or Tilt, so only
high position is set.
successfully
INTERN AL LIBRAR Y CONFI GURATION
Sel ec t ITEM
[ ]CREA TE NEW FI XTURE
Selec t fea ture to con figu re for
esc
ok
FIXTURE NAME - [ ]PAN/ TILT PATCH
X(PAN) Y(TILT) PAN/ TILT
H[ -- ]
esc
ok
OUTPUT
L -- H -- L --
Selec t fea ture to con figu re for
esc
ok
FIXTURE NAME - [ ]PAN/ TILT PATCH