Specifications

Setup Menu
Getting acquainted
First, make sure this console is in Fixture control mode by observing the Fixture LED
indicator and LCD Screen on upper-right. The Fixture LED indicator will be lit and
the LCD Screen will show the message "Select Fixture".
Press the Setup button to activate Setup mode. A yellow LED above the button will
blink briefly and the overhead LCD Screen will show the message "Configuration &
Setup Menu" indicating you're in Setup menu.
The Setup menu contains 11 submenus, namely Internal Library, Patch, MIDI Channel,
Strobe Type, Gooseneck Dimmer, View Free Memory, Send Data File, Load Data File,
Update Software, Save to Card and Load from Card.
CONFIGURATION & SETUP MENU
esc
ok
SELECT [ ]INTERNAL LIBRARY
1. Internal Library
Press the Setup button to access Setup menu. Move the Fader 4 or press the
Up/Down buttons until the LCD Screen shows [ Internal Library ] in the bottom line.
INTERNAL LIBRARY CONFIGURATION
Select ITEM
[ ]CREATE NEW FIXTURE
Press "ok" to access setting menu, which consists of three(3) options,
including Create New Fixture, Edit Existing Fixture and Delete Fixture.
Hereinafter we will give step-by-step instructions.
1.1 Create New Fixture
Move the Fader 5 or press UP/DOWN buttons until the message [ CREATE NEW
FIXTURE ] appears in the Screen.
Basic Control Parts
Flash 1-12
These 12 buttons are used to bring an individual channel to full intensity. They also are
used in combination with the Flash Page button, to select the scene or the step number
of the chases or shows. "Latch" can be enabled when the buttons are pressed down for
2 seconds.
Flash Page
In combination with the Flash buttons, this button is used to page through pages 1-4
of 12 scenes, 12 steps of the chases or shows.
Channel Bank
This button is used to select the channels between two bank, the first 1-12 channels,
and the second 13-24 channels.
Dimmer Master Fader
This fader is used to control the overall fader output of two banks of
channels(1-12/13-24).
Grand Master Fader
This fader is used to determine maximum output of all dimmer faders.
Preset Faders (1-8)
These 8 faders are used to control the dimmer level of the preset respectively.
Blackout
When pressed, all levels will go to zero. (The flashing LED above the button will
indicate this). Press again, all levels will return.
Audio Button
This button is used to enable or disable audio synchronized control of the selected
scenes, chases, shows and the strobe programs.
6
7
INTERNAL LIBRARY CONFIGURATION
Select ITEM
[ ]CREATE NEW FIXTURE
Press "ok"