Instruction manual

18. Electronic alignment

The display panel at the rear of the CF ZOOM AL allows for the electronic alignment

of motors of the projector’s motors. This procedure is performed by coemar at the factory. It

may be useful to perform this procedure in the case of internal components being

replaced.

Altering the factory settings may redically alter the functioning of the projector.

Carefully read all of the following prior to attempting any changes.

electronic calibration

Important Note: electronic calibration is only possible if the projector is connected

to a DMX 512 source.

1) Press the menu button.

2) Press the + or – button until the display shows rESE (for reset).

3) Press the enter button to confirm your selection then immediately and simulta-

neously press and hold the menu button, holding both pressed for at least 30

seconds. The motors of the unit will perform a reset and the display will show the

following for some few seconds, indicating that you have entered the electronic

calibration mode:

Press the + or – button until the display shows PnAL (for pan alignment, move-

ment of the base motor of the unit).

2) Press the enter button to confirm your selection; the display will show a numeri-

cal value which corresponds to the factory preset.

3) Press the + or – button until the numerical value corresponds with the correct ali-

gnment of the unit (note that with each press of the + or – button the motor will

move).

4) Press the enter button to confirm your selection.

tLAL

1) Press the + or – button until the display shows tLAL (for tilt alignment, move-

ment of the yoke).

function display