Instruction manual

15. Replacing dichroic
Dichroic filters on the colour wheel may be replaced at will; note that any
filters replacements must be Ø 45mm, thickness 1.1 mm and made from tempax high
temperature-resistant glass.
replacing a dichroic filter
1) Remove the inspection lid A of the projector via the two clips A as shown below.
2) Locate the dichroic colour wheel
3) Manually rotate the colour wheel until you locate the colour you wish to replace.
4) Rotate the colour wheel until you reach the empty slot.
Attention
Disconnect mains power prior to attempting any replacement procedure.