Instruction manual

12. DMX 512 signal
If all procedures have been correctly carried out to this point, the 13 channels of
functions your DMX 512 controller will have full control over all the effects available from your
CF ZOOM AL as described in the following table:
channel
function type of control effect decimal
1 Base (pan) coarse proportional coarse control of the base movement 0-255
2 Base (pan) fine proportional fine control of the base movement 0-255
3 Yoke (tilt) coarse proportional coarse control of the Yoke movement 0-255
4 Yoke (tilt) fine proportional fine control of the Yoke movement 0-255
5 dimmer step lamp off 0-128
step Lamp on 129-255
6 shutter step closed 0-9
proportional strobe effect increasing flash rate 10-127
proportional random strobe, increasing flash rate 128-247
step open 248-255
7
Beam size
proportional from flood to spot 0-255
8
filter selection
proportional white clear 0-15
proportional filter 1 vertical alteration of adjustable beam angle 16-217
proportional filter 3 adjustable 218-255
9 color wheel step
WHITE
0-24
step
color 1
25-49
step
color 2
50-73
step
color 3
74-99
step
color 4
100-123
step color 5 124-151
proportional
continuos color wheel rotation clockwise with proportional
speed from min. to max.
152-255
NOTE: channel 9 function can be varied selecting color standard/special function on the back function display
9 color wheel step white clear 0- 9
proportional
proportional 360° color wheel rotation .
10- 151
proportional
continuos color wheel rotation clockwise with proportional
speed from min. to max.
152-255
10 cyan step white clear 0-9
proportional
proportional cyan control from white to cyan
10-255
11 magenta step white clear 0-9
proportional
proportional magenta control from white to magenta
10-255
12 Yellow step white clear 0-9
proportional
proportional yellow control from white to yellow
10-255
13 function step No effect 0-19
step pan/tilt go to sensor 20-100
step all motor reset 101-240
step No effect 241-255
note 1: 2 or 4 numbers close to the end limit levels cannot be used as unstable levels
note 2: function channel has a delay time of 6 second to prevent accidental activation.