Instruction manual

4) Press the + or – button; the display will show oFF (opto deactivated).

5) Press the enter button after either step 3 or 4 to confirm your choice.

N.B. We recommend that the opto be deactivated only if it is obviously defective

and requires replacement.

coLo

This function allows the colour wheel to be used in a proportional manner via DMX

512 signal.

1) Press the menu button.

2) Press the + or - button until the display shows coLo (for colour wheel).

3) Press the enter button to confirm your selection; the display will show Strd (for stan-

dard) which corresponds to the automatic centring of the colours on the colour wheel

in the optical path of the unit. A change in the DMX 512 signal corresponds to a colour

change by the CF ZOOM AL.

4) Press the + or – button; the display shows SPEc (for special) which corresponds

to the proportional selection of the colour on the colour wheel (split colours are

thereby possible)

5) Press the enter button after either step 3 or step 4 to confirm your choice of colour

selection.

tESt

This function allows for a test sequence to be carried out on the respective motors of

the unit in the absence of any DMX signal.

1) Press the menu button.

2) Press the + or - button until the display shows tESt (for test).

function display