Instruction manual

Gob2

This function allows the gobos on gobo wheel 2 (static gobos) to be either centred

in the optical path of the projector or to be utilised in a proportional manner via

DMX 512 signal, thus allowing the creation of split gobos.

1) Press the menu button.

2) Press the + or - button until the display shows Gob 2 (for gobo).

3) Press the enter button to confirm your selection; the display whill show Strd (for

standard) which corresponds to the automatic centring of gobos on gobo wheel

2 in the optical path of the projector

4) Press the + or - buttons; the display will show SPEc (for special) which corre-

sponds to the proportional rotation of gobo wheel 2.

(a variation in the DMX 512 signal corresponds to a proportional rotation of

gobo wheel 2, thus allowing gobos from this wheel to be positioned out of cen-

tre in the optical path of the projector)

5) Press the enter button after either step 3 or 4 to confirm your choice of the man-

ner in which gobo wheel 2 will respond to the DMX signal.

channel

function

type of control

effect decimal

gobo 2 selection

standard (Strd)

step no gobo (clear) 0-23

step gobo 1 24-49

step gobo 2 50-73

step gobo 3 74-99

step gobo 4 100-123

step gobo 5 124-151

proportional gobo wheel rotate continously, speed from min to max 152-255

NOTE: channel 13 function can be varied selecting gobo standard/special function on the back function display

gobo 2 selection

special (SPEc)

step no gobo (clear) 0-10

proportional

proportional gobo wheel rotation 360° from no gobo to the last

gobo

11-151

proportional gobo wheel rotate continously, speed from min to max 152-255

function display