Operating instructions

Pag. 2 http://www.coef.it - [e-mail]
ADVICES FOR A CORRECT INSTALLATION
ATTENTION: carefully read the directions of this manual. Exclusively follow the safety rules in force and do not carry
out assembly and/or maintenance operations without taking all precautions as indicated in the different sections or
without the necessary specialization.
This manual must always accompany the equipment, therefore it must be available and readable at any moment if
necessary. Also in case of sale, rent, change of place and/or ownership, these documents shall be enclosed with the
relative equipment.
This equipment is destined to an exclusively Professional use.
1) Make sure that all the fastening parts of the spotlight are in good condition. Regulate the proportions of the fastening acces-
sories (screws, bushes, nuts, supports, etc.) in order to be slightly over-dimensioned as compared to the actual requirements.
2) Carefully check the contents of the packaging and the completeness of the components. If any of the parts listed hereunder
is missing, please contact your Dealer immediately.
3) Do not install the projector outside where the influence of atmospheric factors could damage the unit working (rain, wind,
intense heat etc.) or indoor if there is a high percentage of humidity.
4) Do not clean the projector using water jets or immersion in different liquids. Scrupulously follow the indications given in the
chapter MAINTENANCE.
5) Make the electric connections and the installation / replacement of the lamp after having disconnected the power supply and
after haved positioned the power switch to OFF.The apparatus is classified as belonging to Class 1 type of protection against elec
-
tric shocks. Its connection to an earthed mains unit is compulsory. The equipment must be protect by an adeguated magneto-
thermal switch. You are recommended to equip the system with aptly dimensioned differential switches.
6) Do not touch in any case the internal and external parts of the projector without previous authorization of the constructor
and make modifications only by the intervention of qualified staff.
7) Make sure that the projector is correctly fixed on the support as indicated in par. 3.3
8) If the bulb explodes, the particular design of the apparatus prevents the splinters from going outside the projector. All the
parts, therefore, shall be complete and perfectly assembled. The lenses, if visibly damaged, shall be replaced by original spare
parts.
9) Minimum distance from illuminated objects:
The projector must be positioned in such a way that objects struck by the
light beam are located at least 1,5 metres from the projector objective.
10) Minimum distance from inflammable materials:
0.1 meters
11) MAX ambient temperature:
40° C.
12) MAX external surface temperature
: 60° C.
13) Don’t look directly the lamp trough the lens.
14) We recommend not to look at the lamp without wearing a proper protection; also ensure that the covers are assembled to
the equipment.
15) Inside the equipment there are high temperatures and tension/current values which might be very dangerous. It is
necessary to disconnect the equipment from the mains before removing its protection covers and wait for 30 minutes at least
before touching any part inside.
16) Do not switch on the equipment if its lamp is not inserted.
17) Leave sockets and air outlets free from encumbrances and clean them periodically (see “Maintenance” section).
18) Do not leave the packaging elements (polystyrene, nylon, metal parts, etc.) unattended.
1,5 mt.
Declaration of CE Conformity
We, Manufacturer/Importer COEF srl. Via Albinatico, 80-82 / 51019 Ponte Buggianese (Pistoia) ITALY
Declare that the products
Performance 250 DV
Performance 250 DVP
are in conformity with in accordance with 89/336 EEC-EMC Directive and with the actual required safety
standards in accordance with LVD 73/23 EEC