Operating instructions

Pag. 14 http://www.coef.it - [e-mail]
11.0 TROUBLESHOOTING
PROBLEM CAUSE ACTION
The projector doesn’t swich on
The projector swiches on but doesn’t
answer to commands
Defecting projection
Projection with halo
The color or other effects doesn’t
coincide to the selected value.
The PAN or TILT movement doesn’t
coincide to the selcted value
- The power supply is not present
- The lamp is not working
- The thermal switch is active
- Wrong DMX configuration
- Defective cables
- LED A is off
- Defective control unit
- The lens is broken
- Dust or grease stored on the all parts
of projector
- Dust or grease stored on the all parts
of projector
- Position sensor dirty with dust or grea
-
se
- Defective motor
- Electronic board
- Defective motor
- Electronic board
Check if the luminous indicator is lighted or not.
Replace the lamp.
Just to wait for little of time
Make sure that the projector is correctly confi
-
gurated.
Replace or repair the DMX cable.
Check the control unit & DMX cable
Check the control unit by means of other wor
-
king projectors.
Technical aid is required.
Check that the lens are not broken.
Remove dust or grease stored on lenses.
Carefully clean the optical group lenses and the
projector components (see “Maintenance”
chapter).
Carefully clean the optical group lenses and the
projector components (see “Maintenance”).
Technical aid is required.
Technical aid is required.
12.0 DIMENSION & COMPONENTS
DO NOT OPEN THE LAMP COVER BEFORE
HAVING DISCONNECTED THE POWER
HAVING DISCONNECTED THE POWER
CAUTION:
S/N
PIN1: GND
PIN1: GND
PIN2: SIGNAL-
PIN2: SIGNAL-
PIN3: SIGNAL+
PIN3: SIGNAL+
PIN3: SIGNAL+
PIN3: SIGNAL+
IN OUT
380
1
2
3
4
5
4 6
7
1
175
620
8
1
9
10
250 DVP
LIST OF PARTS
1 - Lock Knobs
2 - DMX IN
3 - DMX OUT
4 - Screws for lamp panel
5 - Lamp panel
6 - Mains switch
7 - Mains power soket
8 - Adjustement screws for light beam
9 - Final lens
10 - Focus adjustment