User`s manual

Codonics Virtua User’s Manual 3-27
Setting Up the Software
doIncludeSelfCheckProgram = Specifies whether to include a self-check program on
the disc.
Choices are: True, False.
If True, the recorded disc will include a checksum and
a disc integrity check program. The program can be
run to check whether the original recorded data on the
disc has been altered, whether the disc is a copy of
an original, or whether the disc data has been
corrupted over time or through improper handling.
doVerifyDiscsAfterRecord = Specifies whether to perform a read-after-write disc
verify as part of the data recording.
Choices are: True, False.
If True, a data integrity check will be performed on the
disc automatically at the conclusion of the recording
operation.
Verifying discs can double the record time, but
provides the greatest assurance that the study data
has been recorded properly.
doPrintToDicomImager = Not currently supported.
dicomImagerName = Not currently supported.
doLimitStudiesPerDiscToLabelCapacity = Specifies whether the number of studies recorded on
a disc will be limited by the amount of study
information that can be printed on the disc label.
Choices are: True, False (the default).
If True, the study capacity of the disc will be limited to
the maximum number of studies that can be included
on the disc’s printed label. This could cause the job to
be recorded across multiple discs.
physicianCopies= Specifies the number of disc copies to make for the
physician.
patientCopies= Specifies the number of disc copies to make for the
patient.
Table 3-5. Job Profile Format and Parameters (Continued)
Parameter Description