User`s manual


15. Select “No” to print a test page. Select “No” to the
option: Do you want to print a test page? as shown
in the dialog box below. The test print will be made
later after the printer network module is
configured. Click [ Finish] to complete the driver
installation.
16. Driver Installation Complete. When the printer
driver has successfully installed, remaining
windows on the screen will clean-up and close.
Network Module Configuration
It is important when configuring the Network Module
that the printer and computer are on the same network
subnet. This usually means that they share the same
network hub.
1. Open a DOS command prompt window. Open a
command prompt using the Windows “start”
button sequence:
start -> Run...
Type “cmd” in the box and click [ OK ]
2. Run the “set-ep1000.exe” command. Type the
following command in the Command Prompt
window:
C:\CODONICS\bin\set-ep1000
3. Online help is available if needed. The set-
ep1000.exe program has basic help to explain the
terminology and parameters needed to configure
the network address on the Network Interface
Module. Type “Y” < Enter > if help is needed. The
instructions in this document will explain the steps
needed to configure the module.
4. Enter the Ethernet address of the Network
Interface Module. Each Network Interface module
has a unique Ethernet address assigned to it at the
factory. This address is printed on a label on the
back of the module. Enter the Ethernet address as
shown in the example below:
E/N: 00-40-17-XX-XX-XX