User`s manual



1. Login as Administrator. Adding a printer to

Windows NT 4.0 requires administrator privileges.

password.

2. Locate the file “EP1000_WinDriver.exe” on the

CD. The EP1000_WinDriver.exe file is provided on

the print driver CD-ROM. Insert the CD into the

CD-ROM drive of the PC and locate the file on the

CD.

3. Run the program “EP1000_WinDriver.exe”. Start

EP1000_WinDriver.exe by double-clicking the file

name. The dialog box shown below will be

displayed. Click [ OK ] to continue with the

installation.

4. Make sure no print jobs are running. The Print

Driver cannot install if any other print jobs are

running. The following dialog box will appear to

remind the user. Make sure that all other printers

are inactive before proceeding. Click the [ Setup ]

button to continue. The installer will unzip the

driver files and copy them to the directory:

C:\CODONICS

5. Remove any old EP-1000 Print Driver

components. The installer will automatically

check for older EP-1000 print driver components

and delete them. A dialog box similar to one below

will be displayed. If any old components are found,

a prompt will ask the user if these components

should be removed. It is strongly recommended

that all old print driver components be removed by

typing: Y <Enter>. If no components are found, the

dialog box will not prompt for any response.

6. Set-up of network printer port. The installer will

open the window shown below. Type the IP

address of the printer in the Hostname or IP

address box. Check with your system

administrator for the proper IP address. This is the

same IP address that will be used later to configure

the network module. In the example below an IP

address of 192.168.1.200 has been entered. Click [

OK ] to continue with the installation.