Manual

SPECIAL NOTES
• Beforeinstallingthelock,loadthebatteriesandfamiliariseyourself
with the operation and programming.
• Thehandlewillnotturnuntilyouenterthefactorydefault
Master Code 11 33 55 77 OR the User Code 22 44.
• Pleaseseeprogrammingguidetosetyourowncodes.
INSTALLATION GUIDE
A) Replacing existing cam lock with
the KitLock
Step 1 Remove existing cam lock.
Step 2 Place template over hole left by cam lock and mark
upper fixing hole.
Step 3 Drill the 6mm (
1
/
4
”) upper fixing hole.
Step 4 Fit the KitLock to the door by passing the spindle
through the 16mm (
5
/
8
”) hole.
Step 5 If required, from the inside of the door, pass either of the
packing pieces over the spindle to centralise the lock.
Step 6 Now secure the lock by threading the large nut onto
the spindle.
Step 7 Fit one of the upper fixing bolts to suit your
door thickness.
Step 8 Tightenthelowerfixingnutandupperbolt.
FITTING INSTRUCTIONS
TheKitLockcanbefittedto:
A) Cupboards, cabinets and lockers etc as a direct replacement for
existing cam locks.
B) It can also be easily fitted to cupboards and cabinets that do not
have an existing locking device.
1 KitLock
2 Upper fixing bolt x 2
3 Packer pieces x 2
4 Locking nut
5 Cams x 2
6 Cam fixing bolt
 • Batteries–2x1.5VAAA
 • Templatex1
1
2
3
456