User manual

D013597_02_CR3600_User_Manual
25.0 - Pre-Installed Applicaons
The CR3600 ships with three pre-installed applicaons: Admissions, ID Vericaon, and Inventory. The three applicaons will appear
during inial boot-up of the reader; and can be accessed at a later me by selecng the ‘Applicaons’ opon and then ‘Run apps’.
Select the applicaon by toggling the up and down arrows located above the keyboard. Highlight and press the center ‘enter’ buon
found between the arrow buons once an applicaon has been selected.
Admissions Applicaon
The Admissions applicaon will display two sub-categories; Events and Tradeshow. (Figure 37)
Events
The following screen (Figure 38) will appear when the Events applicaon is selected. Press the so key buon located below the
word ‘Opons’ (Figure 39) to run the applicaon. The ‘Event opons’ screen provides a list of integrated features and funconality.
(Figure 40)
Scan cket: acvates the
reader to begin scanning
ckets. Ticket informaon
that appears on the screen
aer a cket is scanned is
based on the data contained
in the barcode.
Hourly totals: this screen
provides hourly updates based
on the number of ckets
scanned.
Event totals: provides
event updates based on
the number of scans taken
during a specic day or the
event as a whole.
Check cket: enables the user
to scan a cket to determine
cket validity or to list the
number of mes the cket has
been used.
Saving to le?: allows the
user to save the scanned
data to le. The data will
be saved under the name
demoEvent_log.demo.
13
Figure 37 Figure 38 Figure 39
Figure 40