User manual

D013597_02_CR3600_User_Manual
14.0 - Communicang in USB Downloader (HID) Mode
CR3600 rmware and conguraon sengs can be managed via USB Downloader (HID) Mode using Code’s CortexTools™.
If you are using the CR3600 with a CodeXML® M3 Modem, skip to step 2.
For the CR3600 to communicate in wired, USB Downloader (HID) Mode with a Charging Staon with embedded CodeXML® modem:
1. Move the Communicaon Mode Switch to the le (opposite direcon of the arrow) on the Charging Staon (Figure 16).
2. Open CortexTools™.
3. Scan the USB Downloader (HID) Mode conguraon barcode.
4. Dock the reader into the Charging Staon.
5. Follow the instrucons detailed in the CortexTools™ User Manual, available from
www.codecorp.com.
Note: to manually switch to USB Downloader Mode follow these steps.
1. Select ‘Opons.’
2. Select ‘Sengs.’
3. Select ‘Communicaon.’
4. Select ‘USB.’
5. Select ‘Downloader.’
6. Select ‘Save.’
USB Downloader (HID) Mode
Conguraon Code
Batch mode allows a user to store scanned data to the reader’s non-volale memory. The user may transfer the data to a host device
when needed.
The CR3600 may be congured to operate in three dierent modes:
1. Batch Mode Disable (Default) - In default mode, data is NOT stored in memory. The CR3600 will automacally detect when the
Bluetooth radio is out of range, and will beep 4 mes each scan to indicate this. The CR3600 will automacally reconnect when
the Bluetooth radio is in range.
2. Log Only Mode - In Log Only Mode, the reader will only store data to its memory.
• The data can ONLY be retrieved by scanning the “Transfer Stored Data in Memory” barcode. Scanning the “Transfer Stored
Data in Memory” barcode will transfer the data to the host device, but not delete the data from the reader’s memory.
• A user must scan the “Delete Buered Scanned Data from Memory” barcode to clear reader memory.
• The CR3600 will reconnect to the Bluetooth radio when the “Transfer Data in Memory” or the QuickConnect Code is scanned.
• Auto reconnect is disabled when Log Only is enabled.
3. Send & Log Mode - In Send & Log Mode the reader will store a copy to its memory as well as send the data if the reader is
connected.
• The data can be retrieved by scanning the “Transfer Stored Data from Memory” barcode. Scanning the “Transfer Stored Data
in Memory” barcode will transfer the data to the host device, but not delete the data from the reader’s memory.
• A user must scan the “Delete Buered Scanned Data from Memory” barcode to clear reader memory.
• The CR3600 will reconnect to the Bluetooth radio when the “Transfer Data in Memory” or the QuickConnect Code is scanned.
• Auto reconnect is disabled when Log Only is enabled.
Aer a successful decode in batch mode, the unit will beep once and the memory LED will turn green indicang stored memory.
15.0 - Communicang in Batch Mode via USB Communicaon Mode
8