User manual

D013597_02_CR3600_User_Manual
13.0 - Communicaon Mode Switch
Charging Staons with an embedded modem feature a Communicaon Modem Switch. The
Communicaon Mode Switch allows the reader to transmit data through either the modem or
wired connecon.
When the Communicaon Mode Switch is moved to the right, in the direcon of the arrow, the
reader will communicate via the modem. The QuickConnect code located on the front of the
Charging Staon must be scanned to establish a Bluetooth connecon. Scanned data will then be
transmied to the host device wirelessly.
If a wired connecon is needed, move the Communicaon Mode Switch to the le. For USB
Downloader or Keyboard mode, the Batch Mode Enable code must be scanned (refer to Secon
10). To transmit scanned data while in wired mode, the reader must be placed into the Charging
Staon before data can be transmied to the host device.
12.0 - How to Manually Enter Data
1. Begin at the ‘Ready’ prompt. (Figure 27)
2. Select ‘Opons.’ (Figure 27)
3. Select ‘Enter data.’ (Figure 28)
4. You can enter numbers, text, or symbols. Press the SHIFT key to toggle between entry modes. (Figure 29) Press a key mulple mes to
cycle through the available leers. Press the 0 key mulple mes to cycle through all the available symbols. (Figure 30)
5. When done entering data, press the Enter key to send the data. (Figure 31)
Figure 27
Figure 28
Figure 29
Figure 30
Figure 31
Enter Button
Communicaon
Mode Switch
7