Technical information

10/29/2014
Page 64 of 72
© 2014 The Code Corporation  12393 South Gateway Park Place Suite 600, Draper, UT 84020  [phone]  FAX [phone]
Reg
Setting Name
Default
(Hex)
Comment
2CE
Motion Detection
Pattern Option
1
This setting defines the type of pattern detection to be applied
after initial motion is detected.
Bit
Controls
Value
0
Basic pattern detection. It has fast
response time and can be used for
general applications.
0: Disabled
1: Enabled
1
Advance pattern detection. It has better
detection for low contrast labels and 2D
barcodes but is slower.
0: Disabled
1: Enabled
Note:
 Without applying any pattern detection (value as 0), the reader will
capture an image for decoding when any motion is detected.
 When Basic pattern detection is not sensitive enough for some cases,
you can turn both Basic and Advance pattern detection ON (value as
3). In this situation, most of the cases will be detected by the Basic
pattern detection with fast response time and the Advance pattern
detection can detect low contrast labels and some 2D barcodes.
2CF
Re-sleep Timer (ms)
FFFFFFFFF
FFFFE0C
(#-500)
(disabled)
CR4405:
45000
(#282624)
If the auto wake feature is enabled (register 2D0: Full Wake
Duration > 0), when the reader auto-wakes from low power sleep
mode, it will stay awake for this amount of time (ms) before going
back to low power mode. This assumes the user does not perform
some other action that would “wake” the reader normally, like
press a button.
Also see register: 2D0, 32, 88, 8E, 9F, 2C, 9E
2D0
Full Wake Period (sec)
FFFFFFFFF
FFFFE0C
(#-500)
(disabled)
CR4405:
900 (15
min)
If greater than zero, this is the amount of time (sec) that the reader
will remain asleep before auto-waking for the duration defined in
register 2CF. If zero or negative, feature will be disabled and the
reader will never auto-wake.
Also see register: 2CF