Technical information

10/29/2014
Page 62 of 72
© 2014 The Code Corporation  12393 South Gateway Park Place Suite 600, Draper, UT 84020  [phone]  FAX [phone]
Reg
Setting Name
Default
(Hex)
Comment
2CA
Extended Duplicate
Block Time Options
1
Binary Dip Switch
Bit
Controls
Value
0
Use extended duplicate block time if
stand detected
0: Disabled
1: Enabled
1
Use extended duplicate block time if in
motion detection mode
0: Disabled
1: Enabled
2
Use extended duplicate block time if in
continuous scan mode
0: Disabled
1: Enabled
3
Always use extended duplicate block
time
0: Disabled
1: Enabled
Also see register: 159, 21C
2CB
iPhone Onscreen
Keyboard Release Delay
(ms)
7D0
(#2000)
When the iPhone receives keyboard data from the sled, the
onscreen will disappear before sending the first character, and
reappear after receiving the last character. This setting is the
number of milliseconds that the onscreen keyboard will remain
hidden after receiving the last character from the sled. Supported
in firmware levels 887+.
Note: Supported on CR4405 only.
2CC
Allow sending USB scan
codes over a Bluetooth
SPP connection
1
0: Disabled
1: Enabled
If Enabled, the reader will send data as USB scan codes to a modem
that requests this behavior, instead of sending just the decoded
bytes. If Disabled, or if the modem does not request USB scan
codes, the reader will send the data as the decoded bytes.
Note: Supported on Bluetooth readers only.