Technical information

10/29/2014
Page 61 of 72
© 2014 The Code Corporation  12393 South Gateway Park Place Suite 600, Draper, UT 84020  [phone]  FAX [phone]
Reg
Setting Name
Default
(Hex)
Comment
2C5
Minimum Initial Battery
Percent to power
iPhone
5
In iPhone communication modes (Apple App mode and Apple
Keyboard mode, currently) the reader will not provide any power
or communication channel to the iPhone until it has confirmed that
the sled battery is above this percent.
Note: Supported on CR4405 only.
Also see register: 282, 283, 284, 285, 29C, 29D, 2AF, 2B0, 2C5
2C6
Keyboard minimum
inter-character delay
(ms)
0
Require at least this amount of time between characters sent over
a keyboard interface. Any value below 3 ms will have no noticeable
effect.
Also see register: 2C7, 2C8
2C7
Keyboard minimum
inter-scan code delay
(non-release scan code)
(ms)
0
Require at least this amount of time since the last scan code sent
over a keyboard interface (this setting is used when the scan code
to be sent is not a release scan code). Any value below 3 ms will
have no noticeable effect.
Also see register: 2C7, 2C8
2C8
Keyboard minimum
inter-scan code delay
(release scan code) (ms)
0
Require at least this amount of time since the last scan code sent
over a keyboard interface (this setting is used when the scan code
to be sent is a release scan code). Any value below 3 ms will have
no noticeable effect.
Also see register: 2C7, 2C8
2C9
Enable vibrate in stand
0
0: Disabled
1: Enabled
If Enabled, this setting will allow the reader to vibrate when in the
stand. The default is to prevent vibration of the reader while in the
stand.
Note: Readers with a vibration motor are the CR1400, CR2600,
CR3600 and CR6000.