Technical information

10/29/2014
Page 58 of 72
© 2014 The Code Corporation  12393 South Gateway Park Place Suite 600, Draper, UT 84020  [phone]  FAX [phone]
Reg
Setting Name
Default
(Hex)
Comment
29C
Device Battery Critical
Level
19
(#25)
Only applies to charging mode 2 in charging mode register 284. If
device battery drops below this level, sled will start charging the
device.
Note: Supported on CR4405 only.
Also see register: 282, 283, 284, 285, 29C, 29D, 2AF, 2B0, 2C5
29D
Sled Battery Reserve
Level
28
(#40)
Only applies to charging mode 2 in charging mode register 284.
Sled will charge device battery until sled battery drops below the
percentage value in this register.
Note: Supported on CR4405 only.
Also see register: 282, 283, 284, 285, 29C, 29D, 2AF, 2B0, 2C5
29E
Lower battery percent
scaling
0
Reader will report 0% battery capacity if the actual battery drops
below this percent.
29F
Upper battery percent
scaling
64
(#100)
CR4405:
5A
(#90)
Reader will report 100% battery capacity if the actual battery rises
above this percent.
2A8
Use demo script
0
CR3600:1
Setting this parameter to a 1 on a device that has a display will
cause the device to use the demo script instead of the “.default.js”
script.
2AB
Detect charging base as
stand
0
If set to 1, for readers with a charging base, the reader will be
considered “in the stand” if the reader is in the charging base.
Note: Applies to Bluetooth readers only.
Also see registers: 2BE, 2BF, 2C0, 2C1, 2C2, 2C3
2AF
USB passthrough mode
minimum battery
capacity (%)
5
When in USB passthrough mode, if the sled battery drops to or
below this level, the sled will stop providing power to the iPhone.
Note: This will cause a communications failure between the iPhone
and the USB host, but it is necessary to prevent sled reboots that
would also cause communications failures.
Note: Supported on CR4405 only.
Also see register: 282, 283, 284, 285, 29C, 29D, 2AF, 2B0, 2C5