Technical information

10/29/2014
Page 47 of 72
© 2014 The Code Corporation  12393 South Gateway Park Place Suite 600, Draper, UT 84020  [phone]  FAX [phone]
Reg
Setting Name
Default
(Hex)
Comment
159
Ignore Duplicate Code
(ms)
0
Valid Range: 0 to 7FFFFFF Milliseconds
Consecutive duplicate codes (i.e., codes that contain the same
data) are blocked for this amount of time (in milliseconds). 0 turns
off blocking of duplicate codes.
Also see register: 21C, 2CA
172
Automatically save the
Bluetooth connection
address
CR2300:
CR2600:
CR3600:
1
0: Disable
1: Enable
The address in the QuickConnect code will be saved if enabled.
Note: Only applies to readers using Bluetooth communication
modes.
173
Enable Bluetooth
Encryption
0
0: Disable
1: Enable
Full wireless link encryption support for Bluetooth readers added in
0476+.
Note: PIN must be set to the same value on the reader and remote
device for connection to be successful. For Code Modems, please
refer to the D018582 Modem ICD document for details on the
setPin command.
181
Glare Detection
(Reduction)
0
0: Disabled
1: Enabled
1EA
Good Read Duration
(ms)
C8
(#200)
Valid Range: 0 to 7FFFFFF Milliseconds
Affects beep and vibrate duration.
20E
Motion Detection: Start
Delay (ms)
0
Valid Range: 0 to 7FFFFFFF Milliseconds
A built-in delay of 200 ms prevents motion detect from detecting
motion right after a successful decode. This allows the barcode to
be removed without triggering a new decode. Use this register to
add an additional delay amount to the built-in delay.
Also see registers: 86, 204, 20E
218
Motion Detection
Option
0
Binary Dip Switch with bits 1 & 2 comprising a value
Bit
Controls
Value
1
CR6000
Illumination
0: Dark Field illumination
1: Diffuse Bright Field
2
2: Direct Bright Field
3: Dark Field and Diffuse
Bright Field