Technical information

10/29/2014
Page 36 of 72
© 2014 The Code Corporation  12393 South Gateway Park Place Suite 600, Draper, UT 84020  [phone]  FAX [phone]
Reg
Setting Name
Default
(Hex)
Comment
88
Sleep Timeout (sec)
CR2300:
CR2600:
CR3600:
A8C0
(#43200,
12 hours)
Valid Range: 0 to 7FFFFFFF Milliseconds.
This state: Sleep (Lowest power usage)
Next state: Power off
Counts down to the end of Sleep Mode and then the device powers
off. To disable this timer, set the register value to -1 as in the
following example which disables and saves the timer setting with
the ‘C’ command:
C(88)#-1
Note: Only applies to readers using Bluetooth communication
modes.
Also see registers: 32, 88, 8E, 9F, 2C, 9E
8C
USB Virtual
Communications
Common Mode
1
0: Disabled
1: Enabled
Every reader with USB Virtual Communications Common Mode
enabled will use a common VCOM port on the host PC. A reader
with this setting disabled will use a unique VCOM port.
Note: This setting is only valid for CR8000/1000/1400/900FD/6000
and can be enabled only with PC VCOM Driver 2.1.0 or above and
Reader firmware 0956 and above.
8E
Time In Idle Mode (ms)
CR2300:
CR2600:
CR3600:
1388
(#5000)
Valid Range: 0 to 7FFFFFFF Milliseconds
This register defines the amount of time in Idle Mode before
entering Standby Mode. Other than the quicker transition to Active
Mode, the Reader is in a state very similar to Standby Mode.
Communications: Enabled
Current state: Idle (Mid power usage)
Next state: Standby
Note: Only applies to readers using Bluetooth communication
modes.
Also see registers: 32, 88, 8E, 9F, 2C, 9E