Technical information

10/29/2014
Page 19 of 72
© 2014 The Code Corporation  12393 South Gateway Park Place Suite 600, Draper, UT 84020  [phone]  FAX [phone]
Reg
Setting Name
Default
(Hex)
Comment
00
Bluetooth® Radio
Out-of-range indicator
0
Binary Dip Switch
Bit
Controls
Value
0
Vibrate
0: Disabled
1: Enabled
1
Beep
0: Disabled
1: Enabled
Note: Readers with a vibration motor are the CR1400, CR2600,
CR3600 and CR6000.
04
Continuous Illumination
During Read
0
0: Minimal Illumination (Illumination stops whenever not needed
during the Read Cycle – this produces a little more flashing but
reduces power consumption to a degree)
1: Leave Illumination On Until End of the Read Cycle
Leave illumination on during read
05
USB Declaration Wait
State
0
0: Declare enumeration after receipt of set LED status report
1: Declare enumeration after receipt of get report descriptor
command (used for some Windows CE-based devices)
Special case for USB enumeration that doesn’t require Host
keyboard response
08
Reader Packet Format
1
1: Raw Mode
2: Packet Mode
4: Encrypted Packet Mode (Version 2)
5: AES Encryption Mode (Version 4)
6: Safe Upgrade Mode (Version 1)
This setting is used in conjunction with registers 1B and 42 to
configure the communication mode between standard “one-way”
and “two-way” modes.
For example, USB “two-way” native:
1B: 5 (USB Native)
08: 2 (packet mode)
42: 1 (expect response)
Also see registers: 1B, 42