User`s manual
Part 4
CR4001 / 4101 / 4211
1). Connect the drawer serial I/P port to the computer COM port. Connect
the power adapter output to the Power Input jack
2). No other RS232C devices should be connected to the serial O/P port.
3). Set position 3 of S2 to OFF and position 4 of S2 to ON. Please refer to
rear panel illustration.
CR4002 / 4102 / 4212
1). Connect the drawer serial I/P port to the computer COM port. Connect
the power adapter output to the Power Input jack.
2). Other RS232C device can be connected to the serial O/P port when
needed as long as the security code makes no influence to this RS232C
device.
3). Set position 3 of S2 to ON and position 4 of S2 to OFF. Set S1 for
security code to open cash drawer. In normal practice, the security code
is suggested to be a non-displayable ASCII character, for example, a
hexadecimal number between 01 to 1F. Please refer to rear panel
illustration below.
CR4003 / 4103 / 4213
1). Connect the drawer parallel I/P port to the computer LPT port. Connect
the power adapter output to the Power Input jack.
2). Other parallel device such as a printer can be connected to the parallel
O/P port when needed as long as the Security code makes no influence
to this parallel device.
3). Set S1 for security code to open cash drawer. In normal practice, the
security code is suggested to be a non-displayable ASCII character. For.
example, a hexadecimal number between 01 to 1F. Please refer to rear
panel illustration below.
CR4001/ 4101/ 4211/ 4002/ 4102/ 4212/ 4003/ 4103/ 4213 Rear panel
illustration.
AC 12V I/P
SERIAL O/P (DB9M)
SERIAL I/P (DB9F)
PARALLEL O/P (DB25F)
PARALLEL I/P (DB25M)
18 41
GROUND
S2S1
Switch is ON when pushed up