User manual

C006819_03_CR1400_User_Manual
4.0 - Using a CR1400 Out of a Universal Stand
Press and hold the CR1400 trigger, the two blue bars eming from
the reader are used for targeng. Center the blue bars in the middle
of a bar code. The opmal reading distance from reader to bar code is
approximately 4.0” (10 cm).
Once the reader is at the opmal distance, the reader will read the bar
code. The CR1400 will beep, ash a green LED and vibrate to indicate a
‘good read’ has occurred.
5.0 - Using a CR1400 in a Universal Stand
Revision 2 Hardware of the CR1400 has a stand detecon feature. By default,
when the CR1400 is placed in the stand, the reader will automacally enter
into moon detecon mode. When in this mode, simply place a bar code in the
scan eld to acvate the reader. The CR1400 will beep and ash a green LED to
indicate a ‘good read’ has occurred.
When the CR1400 is removed from the stand, the reader switches to manual
mode and the trigger must be pressed to read a bar code (refer to Secon 4.0).
Revision 1 Hardware of the CR1400 does not have an automac stand detecon
feature to enable moon detecon reading when the CR1400 is in a stand. To
congure this hardware revision for moon detecon scanning, please refer to
the CR1400 Conguraon Guide, located at www.codecorp.com/les.php and
scan the appropriate code.
2
See Secon 10.0 to learn how to determine your CR1400
hardware revision number.
To modify any default sengs, download the CR1400 Conguraon Guide
at www.codecorp.com/les.php and scan the appropriate code.