User manual

C006819_03_CR1400_User_Manual
2.0 - Aaching and Detaching a Cable
1.0 - Unpacking
Remove the CR1400 from its packing and inspect it for damage. If the reader was damaged during shipping, please call Code at
[phone].
Depending on the kit ordered, a USB or RS232 Anity® cable has been included with your reader.
USB Anity® Cable
RS232 Anity® Cable
w/ Power Supply
For USB Cable: plug the USB end of the Anity® cable into a USB port on the host device. Aer several seconds, the reader will beep
twice, the reader will vibrate, and the LED will turn o to indicate the CR1400 is ready for use.
For RS232 Cable: plug the power supply into the AC outlet, plug the power supply cord into the barrel jack of the cable, and connect
the RS232 connector to the appropriate serial port on the host device. Aer several seconds, the reader will beep twice, the reader
will vibrate and the LED will turn o to indicate the CR1400 is ready for use.
To aach a cable, plug the RJ-50 end of the Anity® cable into boom of the reader handle (Figure 1). Firmly push the connector into
the reader, unl a snap can be heard to indicate the cable is properly aached. To detach a cable, press a paper clip into the hole on the
side of the CR1400 handle (Figure 2), and gently pull the cable from the reader.
3.0 - Powering On/O the Reader
1
Figure 2
Figure 1