User`s manual

PREAMBLE

0) ENTER PREAMBLE

This set of user-defined characters is transmitted at the

beginning of bar code data. To define the PREAMBLE, scan

up to 15 characters from the FULL ASCII chart on the reverse

side of the SETUP MENU. Scan the "ON" bar code when

complete.

1) PREAMBLE SEND DELAY (0.0 - 9.9 SEC)

This option specifies the amount of delay to occur after the

PREAMBLE is transmitted. The delay period is programmable

from 0.0 to 9.9 seconds. The default setting is 0.0 seconds.

2) ACTIVE TYPES

Specifies the types of bar codes that use preambles. Select

one of the following:

A CODE 39 E EAN-8 I CODE 93

B UPC-A F I 2 of 5 J MSI/PLESSEY

C UPC-E G CODABAR K CODE 11

D EAN-13 H CODE 128 L ISBN

X* ALL BAR CODES

POSTAMBLE

0) ENTER POSTAMBLE

This set of user-defined characters is transmitted at the end of

bar code data. To define the POSTAMBLE, scan up to 15

characters from the FULL ASCII chart on the reverse side of

the SETUP MENU. Scan the "ON" bar code when complete.

1) POSTAMBLE SEND DELAY (0.0 - 9.9 SEC)

This option specifies the amount of delay to occur after the

POSTAMBLE is transmitted. The delay period is

programmable from 0.0 to 9.9 seconds. The default setting is

0.0 seconds.

3 CARRIAGE RETURN & LINE FEED

(ASCII 13 & ASCII 10)

4 USER DEFINED TERMINATION CHARACTER