Operating instructions

Operating Instructions Chapter 11

CLV63x Bar Code Scanner

Appendix

Start/Stop operation

In this reading operation mode, only one object per reading pulse is located in the reading

area. Two external sensors or command strings control the beginning and end of the read-

ing pulse for the bar code scanner (stand-alone device). The length of the reading area is

determined in this case by the distance of both reading pulse sensors for the start (begin-

ning of the reading area) and stop (end of the reading area). The minimum reading distance

between two objects must always be greater than the length of the reading area.

In the case of combined use with other bar code scanners in a master/slave combination

(e.g. unidirectional double-side reading), the bar code scanner as a slave receives its pulse

signals from another bar code scanner (master). The bar code scanners are networked via

the CAN interface, the output of the master’s reading result via its RS- 232/RS-422/485

interface and/or the Ethernet interface.

Upload

Transfer process of all parameter values from the connected bar code scanner’s working

memory to a PC in the SOPAS-ET configuration software for display and modification. This

is achieved when the device is connected and communication is successfully carried out af-

ter the scanning process for a confirmed request to synchronise the user interface and the

bar code scanner. Where necessary, this can be triggered manually in the Kommunikation

menu (U

PLOAD ALL PARAMETERS FROM DEVICE Parameter values must be represented in the reg-

ister tabs before the current parameter value set can be modified.

User interface

Windows-oriented input interfaces in the SOPAS-ET configuration software for operation

and configuration of the bar code scanner.