User's Manual

C007964_04_CR2600_User_Manual
4
8.0 - Communicaon Mode Switch
Charging Staons with an embedded modem feature a Communicaon Modem Switch. The
Communicaon Mode Switch allows the reader to transmit data through either the modem or wired
connecon.
When the Communicaon Mode Switch is moved to the right, in the direcon of the arrow, the reader will
communicate via the modem. The QuickConnect code located on the front of the Charging Staon must
be scanned to establish a Bluetooth connecon. Scanned data will then be transmied to the host device
wirelessly.
If a wired connecon is needed, move the Communicaon Mode Switch to the le. For USB Downloader
or Keyboard mode, the Batch Mode Enable code must be scanned (refer to Secon 10). To transmit
scanned data while in wired mode, the reader must be placed into the Charging Staon before data can be
transmied to the host device.
9.0 - Communicang in USB Downloader (HID) Mode
CR2600 rmware and conguraon sengs can be managed via USB Downloader (HID) Mode using Code’s CortexTools™.
To communicate in USB Downloader (HID) Mode with a CR2600 and Charging Staon, skip step 1 and proceed to step 2.
For the CR2600 to communicate in wired, USB Downloader (HID) Mode with a Charging Staon with embedded CodeXML®
modem:
1. Move the Communicaon Mode Switch to the le (opposite direcon of the arrow) on the Charging Staon (Figure 19).
2. Open CortexTools™. (Contact [e-mail] for a CR2600 compable version)
3. Scan the USB Downloader (HID) Mode conguraon bar code.
4. Dock the reader into the Charging Staon.
5. Follow the instrucons detailed in the CortexTools™ User Manual, available from
www.codecorp.com.
USB Downloader (HID) Mode
conguraon code
Communicaon
Mode Switch
The CR2600 can be congured for Batch Mode to capture and transmit data via USB Communicaon Modes. To communicate in
USB Downloader (HID) Mode with a CR2600 and Charging Staon, skip step 1 and proceed to step 2.
For the CR2600 to communicate in wired, USB Downloader (HID) Mode with a Charging Staon with embedded CodeXML®
modem:
1. Move the Communicaon Mode Switch to the le (opposite direcon of the arrow) on the Charging Staon (Figure 19).
10.0 - Communicang in Batch Mode via USB Communicaon Mode